VA - Air Poppets
-
Helps part ejection with Air.
-
Available in a wide range of diameters.
a
VH - High Pressure Air Valves
-
Developed for high injection pressures and high speed cycles.
-
Available in a wide range of diameters.
VD - Double Air Valves
-
An effective method of semi pneumatic ejection, for tools with ribs or areas forming gas traps or vacuum conditions.
FV - Filter Valves
-
Designed for use in thermoplastic molds incorporating a filter to ensure debris cannot affect the units correct function.
a
TH - Hex Key Ext. Tube
-
With Male / Female Threads.
-
With this tube you can simplify all the inlets/outlets so that you only need male fittings.
-
It reduces the need to stock different parts, reducing costs.
SA - Sprue Adjuster
-
This unit allows runner shut off directly from the parting line.
-
Two models are available, with or without ejector bore.
-
It can be installed in the cavity or in the core, allowing trapezoidal or full round runners.
TA - Shock Absorber
-
Used to minimize the vibrations caused by the ejector plates returning to position.
-
The main advantage is the increase in the life of parts within the ejector frame through the reduction of damage and wear.
1
EC - Sprue Bushing
-
When using banana injection in large tools, significant force is needed to extract plastic waste, causing ejector pin breakages and/or H7 ejector hole seize up.
-
In the event of the most common problems, this part can be easily replaced without taking the mold apart, bringing big savings in time and money.
1