RC - Slide Retainer
-
Simple Compact Design.
-
Easy Installation.
-
Minimum space required for installation.
-
Maximum working temperature of 150°C.
a
a
PO - Dowel Pin
-
Optional method for holding the Slide Retainer, that simplifies the disassembling.
-
This item must be ordered separately.
a
a
a
RCM - Slide Retainer
-
Incorporates a mechanical stopper.
-
Minimum space required for installation.
-
Maximum working temperature of 150°C.
a
a
a
RA - Automatic Retainer
-
Retention of cam slides up to 2.000 Kg.
-
The maximum working temperature is 150°C.
4
4
GR - Round Angle Pin Housing
-
This unit incorporates a predrilled hole for the angle pin which eliminates the need to angularly drill the die set.
-
The die set only needs to be drilled from the front to accept this unit.
-
The unit comes in either 10°or 15°.
4
GI - Round Angle Pins
-
This item can be fitted to any of the corresponding Cumsa sets (CG, GR & BG).
aaaa
MG-MC-MB - Mini Slide Set
-
Slide is adjusted, and only requires machining of the part detail.
-
Wedge assembly includes an angle pin and can be adjusted from the mold closed position with a hex key.
-
Base is hardened and includes built-in slide retainer.
a
CG-CA-BC - Slide Set
-
Slide is adjusted, and only requires machining of the part detail.
-
Wedge assemble includes angle pin and can be adjusted from the mold closed position with a hex key.
-
Base is hardened and includes a retainer (RM).
a
MS - Mini Slide
-
Compact slide with faster installation.
-
New floating Insert.
-
Cleanroom appropriate.
-
Available in 3 sizes.
-
The maximum working temperature is 150°C.
4
CS - Compact Slide
-
Compact slide with faster installation.
-
New floating Insert.
-
Cleanroom appropriate.
-
Available in 6 sizes.
-
The maximum working temperature is 150°C.
4
CR - Cooled Compact Slide
-
Compact slide with faster installation.
-
New floating Insert.
-
Cleanroom appropriate.
-
Available in 6 sizes.
-
The maximum working temperature is 150°C.
-
Cooling Available
4
SP - Adjustment Plate
-
Plate used for the installation and adjustment of the CS, CR & MS.
a
UC - Core Cam
-
Mechanism to make lateral holes, automatic retention for the core insert. Requires very small area for installation.
4
UA - Compact Coring Unit
-
This unit uses the open and close movement of the mold to make lateral holes in wall sections of plastic parts. Easy to assemble and remove from the mold.
a
LS - Long Stroke for Slides
-
100% Mechanical Solution 100% Mechanical solution for moving slides with longer strokes without the need for hydraulic cylinders or angle pins.
-
This compact product can be attached to new or existing slides with angles from -25 to +25 degrees with a simple machining.
a